Repair Fuzi Digicams In Calcutta

panu

I have an old Fuzi 3x,2 Mp camera which was stored in a box for long time with batteries loaded ( ). When i recovered it
and tried to operate i found the camera is working but not smoothly as time to time it fails to get on.I think the battery connections have been damaged.


I want to repair it, any possible shop in calcutta???

thejag

if it is only the battery terminals... any shop that repairs other consumer electronics and has the standard tools and a technician with half a brain should be able to help.... if its more than the battery terminals... hopefully some one will be along with a more definitive answer...

PeakXV

The batteries may need replacing &/or the terminals are corroded. If you can get a light abrasive into the battery cavity & give it a rub then you should be back to square one & good to go. I use a pencil eraser sometimes or if it is more heavily corroded then I get some light sandpaper to scrap the contacts a bit. A hole punch can be used to punch out little circles that can be super glued onto a pencil end or you can just roll the sand paper into a long thin cylinder & reach the contacts that way. If your not technically inclined, take it to a dealer and present it to him with these primary assumptions .... and take it from there.

__________________
What lies behind us and what lies ahead of us are tiny matters compared to what lives within us.
~ Oliver Wendell Holmes

Don't go to India ~ Pre-trip Warnings & Misconceptions?